Extreme Digital 2018 Personalized Photo Products
Photo Mug Training Preview


STEP 5: ADJUSTING THE PRESSURE SCREW

         Once you place the mug in the press and attempt to apply pressure you will need to adjust the adjustment screw to either tighten or loosen the heating belt element.
         The pressure will need to be adjusted and this can be accomplished by tightening or loosening the adjustment screw. Minor adjustments may be required between each mug transfer as the heat will make the belt expand and contract. So the pressure adjustments for your first mug might not be applicable for the next mug especially when the Mug Press is new.
         The Mug Press might smell funny the first couple of times you turn the Press on.
         In the photo the screw is being held to emphasis the screw, but be sure and hold the handle until the mug is secured in the press and the transfer process has begun.
         Remove the mug from the press when alerted by the buzzer. The mug handle will not heat up while in the press and will be cool to the touch when you remove the mug. Remove the transfer from the mug and drop the mug in a bucket of cold water.
         Before storing the Mug Press allow it to cool, place a mug in the press, adjust for light pressure and close the Mug Press handle.
EXTREME TRAINING PROGRAM
EXTREME DIGITAL SYSTEM 2018 PHOTO MUG SYSTEM